$A$ wire has a mass $0.3 \pm 0.003 \text{ g}$,radius $0.5 \pm 0.005 \text{ mm}$ and length $6 \pm 0.06 \text{ cm}$. The maximum percentage error in the measurement of its density is (in $\%$)

Two students $P$ and $Q$ perform an experiment to verify Ohm's law for a conductor with resistance $R$. They use a current source and a voltmeter with least counts of $0.1 \, mA$ and $0.1 \, mV$,respectively. The plots of the variation of voltage drop $V$ across $R$ with current $I$ for both are shown below. Which statement is most likely to be correct?

If the length of rod $A$ is $3.25 \pm 0.01 \,cm$ and that of rod $B$ is $4.19 \pm 0.01 \,cm$,then the rod $B$ is longer than rod $A$ by:

The errors in the measurement which arise due to unpredictable fluctuations in temperature and voltage supply are:

The percentage error in the measurement of a physical quantity $m$ given by $m = \pi \tan \theta$ is minimum when $\theta = \dots \dots \dots \dots \dots ^\circ$ (Assume that the error in $\theta$ remains constant).

An experiment is performed to obtain the value of acceleration due to gravity $g$ by using a simple pendulum of length $L$. In this experiment,the time for $100$ oscillations is measured by using a watch of $1$ second least count,and the value is $90.0$ seconds. The length $L$ is measured by using a meter scale of least count $1$ mm,and the value is $20.0$ cm. The error in the determination of $g$ would be ........... $\%$.