Two metal wires $A$ and $B$ have lengths $L$ and $3L$ respectively. The radii of the cross-sectional circular areas of wires $A$ and $B$ are $R$ and $2R$,respectively. These wires are joined end-to-end along their axis. When one end of the combined system is fixed and the other end is pulled with a constant force $F$,the elongation in both wires is equal. If $Y_A$ and $Y_B$ are the Young's moduli of wires $A$ and $B$,respectively,then the ratio $Y_B / Y_A$ is:

$A$ uniform cylindrical rod of length $L$ and radius $r$ is made from a material whose Young's modulus of elasticity equals $Y$. When this rod is heated by temperature $T$ and simultaneously subjected to a net longitudinal compressional force $F$,its length remains unchanged. The coefficient of volume expansion of the material of the rod is (nearly) equal to:

The extension of a wire by the application of load is $3 \ mm$. The extension in a wire of the same material and length but half the radius by the same load is..... $mm$.

$A$ steel rod with $Y = 2.0 \times 10^{11} \, N/m^2$ and $\alpha = 10^{-5} \, ^\circ C^{-1}$ of length $4 \, m$ and area of cross-section $10 \, cm^2$ is heated from $0^\circ C$ to $400^\circ C$ without being allowed to extend. The tension produced in the rod is $x \times 10^5 \, N$ where the value of $x$ is ....... .

$A$ ring of a thin wire of cross-sectional area $a$ and length $l$ is dipped into a liquid of surface tension $\sigma$ and taken out so that a film of liquid is formed in the ring. If Young's modulus of the material of the wire is $Y$,then the longitudinal strain developed in the ring will be:

$A$ block of weight $100 \ N$ is suspended by copper and steel wires of same cross-sectional area $0.5 \ cm^2$ and lengths $\sqrt{3} \ m$ and $1 \ m$,respectively. Their other ends are fixed on a ceiling as shown in the figure. The angles subtended by the copper and steel wires with the ceiling are $30^{\circ}$ and $60^{\circ}$,respectively. If the elongation in the copper wire is $\Delta \ell_C$ and the elongation in the steel wire is $\Delta \ell_S$,then the ratio $\frac{\Delta \ell_C}{\Delta \ell_S}$ is. . . . . .
[Young's modulus for copper and steel are $1 \times 10^{11} \ N/m^2$ and $2 \times 10^{11} \ N/m^2$ respectively]