The internal and external diameters of a hollow cylinder measured with vernier calipers are $(5.73 \pm 0.01) \text{ cm}$ and $(6.01 \pm 0.01) \text{ cm}$ respectively. Then the thickness of the cylinder wall is

Diameter of a steel ball is measured using a Vernier callipers which has divisions of $0.1\,cm$ on its main scale $(MS)$ and $10$ divisions of its vernier scale $(VS)$ match $9$ divisions on the main scale. Three such measurements for a ball are given as:

$S$.No.	$MS\;(cm)$	$VS$ divisions
$(1)$	$0.5$	$8$
$(2)$	$0.5$	$4$
$(3)$	$0.5$	$6$

If the zero error is $-0.03\,cm,$ then the mean corrected diameter is ........... $cm$.

$A$ spectrometer gives the following reading when used to measure the angle of a prism.
Main scale reading : $58.5^{\circ}$
Vernier scale reading : $09$ divisions
Given that $1$ division on the main scale corresponds to $0.5^{\circ}$. The total number of divisions on the Vernier scale is $30$,which matches $29$ divisions of the main scale. The angle of the prism from the above data is ....... $degree$. (in $^{\circ}$)

In a vernier callipers,$(N+1)$ divisions of vernier scale coincide with $N$ divisions of main scale. If $1 \text{ MSD}$ represents $0.1 \text{ mm}$,the vernier constant (in $\text{cm}$) is:

$A$ screw gauge has some zero error but its value is unknown. We have two identical rods. When the first rod is inserted in the screw gauge,the state of the instrument is shown by diagram $(I)$. When both the rods are inserted together in series,the state is shown by diagram $(II)$. What is the zero error of the instrument in $mm$? Given: $1 \, M.S.D. = 100 \, C.S.D. = 1 \, mm$.

$A$ tiny metallic rectangular sheet has a length and breadth of $5 \ mm$ and $2.5 \ mm$,respectively. Using a specially designed screw gauge which has a pitch of $0.75 \ mm$ and $15$ divisions on the circular scale,you are asked to find the area of the sheet. In this measurement,the maximum fractional error will be $\frac{x}{100}$ where $x$ is . . . . . .