As shown in the figures,a uniform rod $OO^{\prime}$ of length $l$ is hinged at the point $O$ and held in place vertically between two walls using two massless springs of same spring constant $K$. The springs are connected at the midpoint and at the top-end $(O^{\prime})$ of the rod,as shown in Fig. $1$,and the rod is made to oscillate by a small angular displacement. The frequency of oscillation of the rod is $f_1$. On the other hand,if both the springs are connected at the midpoint of the rod,as shown in Fig. $2$,and the rod is made to oscillate by a small angular displacement,then the frequency of oscillation is $f_2$. Ignoring gravity and assuming motion only in the plane of the diagram,the value of $\frac{f_1}{f_2}$ is:

  • A
    $2$
  • B
    $\sqrt{2}$
  • C
    $\sqrt{\frac{5}{2}}$
  • D
    $\sqrt{\frac{2}{5}}$

Explore More

Similar Questions

The center of a disk of radius $r$ and mass $m$ is attached to a spring of spring constant $k$,inside a ring of radius $R > r$ as shown in the figure. The other end of the spring is attached on the periphery of the ring. Both the ring and the disk are in the same vertical plane. The disk can only roll along the inside periphery of the ring,without slipping. The spring can only be stretched or compressed along the periphery of the ring,following Hooke's law. In equilibrium,the disk is at the bottom of the ring. Assuming small displacement of the disc,the time period of oscillation of the center of mass of the disk is written as $T = \frac{2 \pi}{\omega}$. The correct expression for $\omega$ is ($g$ is the acceleration due to gravity):

$A$ mass $m$ oscillates with simple harmonic motion with frequency $f = \frac{\omega}{2\pi}$ and amplitude $A$ on a spring with constant $K$. Therefore:

Column $I$ describes some situations in which a small object moves. Column $II$ describes some characteristics of these motions. Match the situation in Column $I$ with the characteristics in Column $II$.
Column $I$Column $II$
$(A)$ The object moves on the $x$-axis under a conservative force such that its speed $v = c_1 \sqrt{c_2 - x^2}$,where $c_1, c_2 > 0$.$(p)$ The object executes simple harmonic motion.
$(B)$ The object moves on the $x$-axis such that its velocity $v = -kx$,where $k > 0$.$(q)$ The object does not change its direction.
$(C)$ An object is attached to a spring in an elevator accelerating upwards with constant acceleration $a$. The motion is observed from the elevator.$(r)$ The kinetic energy of the object keeps on decreasing.
$(D)$ The object is projected vertically upwards with speed $2 \sqrt{GM_e / R_e}$.$(s)$ The object can change its direction only once.

At $t=0$,a particle executing $SHM$ with a time period $3 \ s$ is in phase with another particle executing $SHM$. The time period of the second particle is $T$ (less than $3 \ s$). If they are again in the same phase for the third time after $45 \ s$,then the value of $T$ is .... . (in $s$)

In the figure shown,there is friction between the blocks $P$ and $Q$,but the contact between the block $Q$ and the lower surface is frictionless. Initially,the block $Q$ with block $P$ over it lies at $x=0$,with the spring at its natural length. The block $Q$ is pulled to the right and then released. As the spring-block system undergoes $S.H.M.$ with amplitude $A$,the block $P$ tends to slip over $Q$. $P$ is more likely to slip at:

Vedclass Products

For Students

Vedclass Test Series

Mock tests in real JEE/NEET style with performance analysis. 5-day free trial.

Start Free Trial
For Teachers

Exam Paper Generator

Generate Set A/B/C/D exam papers from 7.5L+ questions in 2 minutes. 3 chapters free.

Try Free
For Institutes

Online Exam Module

Live online exams with unlimited students, 360° analytics & white-label branding.

See Demo