In a diode AM detector,the output circuit has | vedclass

Name: Exam Paper Generator | JEE NEET Paper Generator | Vedclass
Brand: Vedclass
Rating: 5 (35 reviews)

Question

(B) For proper demodulation in an $AM$ detector,the time constant $RC$ must satisfy the condition: $\frac{1}{f_c} \ll RC < \frac{1}{f_m}$,where $f_c$

Vedclass · Accepted Answer

No

Vedclass · Answer

(B) For proper demodulation in an $AM$ detector,the time constant $RC$ must satisfy the condition: $\frac{1}{f_c} \ll RC First,calculate the period of the carrier signal: $\frac{1}{f_c} = \frac{1}{100 	imes 10^3 \ Hz} = 10^{-5} \ s$.Next,calculate the time constant of the circuit: $RC = (10^3 \ \Omega) 	imes (10 	imes 10^{-12} \ F) = 10^{-8} \ s$.Comparing the two,we see that $RC = 10^{-8} \ s$ is much smaller than $\frac{1}{f_c} = 10^{-5} \ s$.Since the condition $\frac{1}{f_c} \ll RC$ is not satisfied,the circuit cannot effectively detect the $100 \ kHz$ carrier signal.

In a diode $AM$ detector,the output circuit has $R = 1 \ k\Omega$ and $C = 10 \ pF$. Can it detect a carrier signal of $100 \ kHz$?

Similar Questions

$A$ full-wave rectifier with diodes $D_1$ and $D_2$ is used to rectify $50 \,Hz$ alternating voltage. The diode $D_1$ conducts .......... times in one second.

The figure shows the current as a function of time at the output of a full-wave rectifier. The average value of this current is:

For the circuit shown in the adjoining figure,to act as a full-wave rectifier,the $AC$ input should be connected across $....$ and $....$ and the $DC$ output would appear across $....$ and $....$.

Explain the use of the junction diode as a half-wave rectifier by drawing a circuit and draw input and output waves.

If in a $p-n$ junction circuit,a square input signal of $5\,V$ is applied as shown,then the output across $R_L$ will be:

Vedclass Test Series

Exam Paper Generator

Online Exam Module